The Ultramax belt has a slot where the SIX PAD SPORT-ELEC® wireless electrode is clipped.

Caution! Never use electrodes other than those supplied by SPORT-ELEC®.

To obtain new electrodes, contact your usual retailer or order them from our website www.sport-elec.com.

1. Connecting and positioning the belt

• Make sure your device is switched off.
• Unfold the belt.
• On the back side of the belt, place the 5x1 electrode with snaps through the belt holes.
• On the front side, place the device and connect it to the SIX PAD electrode through the belt with snaps.
• Stretch the plastic electrode holder.
• Moisten it by spreading a drop of water on the adhesive gel with your fingertips and wait 2 minutes.

    Note: The electrode is intended for personal use. For reasons of hygiene, it should only be used by one person.

• Place the belt around the waist and adjust it with the hook-and-loop fastener so that the electrode is in good contact with the skin.

    If you feel a tingling sensation, switch off the device and check that the electrode is in contact with the skin. If the problem persists, contact Customer Service.

2. Starting the programme with the belt

Once you have connected your device, make yourself comfortable and switch on your device by following the "Switching on the device" procedure.
You can carry out your usual activities while the device is in use.

3. End of programme

• When the program is complete, turn off the unit and disconnect the unit from the electrode.
• Remove from the belt.
• Detach the electrode and moisten it lightly with a few drops of water before replacing it on the transparent plastic holder.